[time-nuts] help

[Bob Camp]

Hi

A cheap GPS module and any of the nearly infinite number of sub $20 “demo boards” would make 
short work of looking at the pps, the time string out of the GPS and figuring out when it’s the top of the 
hour. I doubt it’s over 200 lines of code. I’m sure *somebody* will pop up with an example well below
that. No need for an OS. No need for anything complex. There’s sure to be enough room even on a $2 board
to include added stuff like real time clock driver and correcting the “local time” against GPS. 

Bob

> On May 2, 2016, at 5:36 PM, Nick Sayer via time-nuts <time-nuts at febo.com> wrote:
> 
> 
>> On May 2, 2016, at 9:51 AM, jimlux <jimlux at earthlink.net> wrote:
>> 
>> 
>> The real question is whether "cron" is timely enough.  No matter, just write a script (or python) that reads time in a loop (and you can put a sleep in there) and pulses the GPIO when needed.
>> 
> 
> A Raspberry Pi with nothing else on its plate will have a cron-to-shell script latency easily under 100 ms, possibly under 10.
> 
> If it were me and I were triggering a relay for some sort of external circuit, I’d probably be happy it was on the right side of 500 ms. If I cared more than that, then step 1 would be to do as others have suggested and come up with a microcontroller + GPS solution instead of NTP + cron. Ironically, that’d be around the same price (albeit more engineering work).
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.