[time-nuts] Last Call Group Buy Ublox LEA-6T

Keenan Tims keenan.tims at gmail.com
Thu May 26 06:31:07 UTC 2016


I had some of these boards made:
http://openbsc.osmocom.org/trac/wiki/osmo-lea6t-gps from the Gerbers
in the git repo. I'm running the cheaper LEA-6S modules for
prototyping but the boards seem to work well and were designed for the
pin compatible LEA-6T you're after.

On 25 May 2016 at 23:30, Keenan Tims <ktims at gotroot.ca> wrote:
> I had some of these boards made:
> http://openbsc.osmocom.org/trac/wiki/osmo-lea6t-gps from the Gerbers
> in the git repo. I'm running the cheaper LEA-6S modules for
> prototyping but the boards seem to work well and were designed for the
> pin compatible LEA-6T you're after.
>
> On 20 May 2016 at 01:27, Angus <not.again at btinternet.com> wrote:
>>
>> On Wed, 18 May 2016 05:31:45 +0000, you wrote:
>>
>> >There is what looks like a decent carrier board for Ublox modules on OSHPARK.COM's shared project library.  It has a voltage regulator and RS-232 interface on it... would be nicer if it had a prototype area and swoopty PPS driver,  but I'm too lazy to lay out a better one.  Three boards will cost you $30.
>> >https://oshpark.com/shared_projects/8QR7ymk8
>>
>> Just in case anyone thinking of it has not noticed - that one is for
>> the smaller NEO version rather than the LEA version.
>>
>> So if anyone knows of a LEA version, or has one that they want to
>> upload or whatever... ideally with sawtooth correction  :)
>>
>> Angus.
>>
>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.



More information about the Time-nuts_lists.febo.com mailing list