[time-nuts] TAPR Oncore M12+ kit

[Dave Mallery]

amazing.

especially after a week of effort.

thank you.

dave

On Sat, Apr 22, 2017 at 12:30 PM, Dave Mallery <dave.mallery at gmail.com>
wrote:

> Hi Mark
>
> I was delighted to read about Heather's ability to talk to a timing M12.
> I have been having fits here trying to get the M12 to accept any command
> (using Perl.. a mistake it seems).  i wanted to end up with a Linux capable
> utility and had previously used Perl to parse NEMA on my old TAC2.
>
> I have been learning about binmode(M12) and other edge cases, but am
> probably still far from the eureka moment..
>
> anyhow, i am setting up heather5 for a trial flight.
>
> thanks
>
> dave mallery
>
>
>
> On Fri, Apr 21, 2017 at 8:40 PM, Mark Sims <holrum at hotmail.com> wrote:
>
>> Earlier somebody asked if these were M12's or M12T's.    I powered mine
>> up and connected it to Lady Heather. It appears to be an M12T.   It
>> responds to the survey and position hold commands and outputs the sawtooth
>> correction value.     Also the hardware ID returned is P373T12T12.
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/m
>> ailman/listinfo/time-nuts
>> and follow the instructions there.
>>
>
>
>
> --
> Dave Mallery, K5EN                 (ubuntu linux 16-10)
> PO Box 15                              Ophir,  OR  97464
>
>       linux counter #64628 (since 1997)
>
>
>
>


-- 
Dave Mallery, K5EN                 (ubuntu linux 16-10)
PO Box 15                              Ophir,  OR  97464

      linux counter #64628 (since 1997)