[time-nuts] End-of-Range: Oscilloquartz OCXO 8600-3
Angus
not.again at btinternet.com
Fri Dec 8 21:24:22 UTC 2017
That near the end of the temperature range the direction could also
give a good indication - assuming that there is only one problem...
I think the 8600-3 is still an AT - the 8607 is SC.
Angus.
On Fri, 8 Dec 2017 15:40:08 -0500, you wrote:
>Hi
>
>One basic question - Is the frequency high or low?
>
>Assuming its an SC and on the lower turn, frequency low is possible
>with an off temperature oven. Frequency high is unlikely unless its *way*
>off temperature. How far off turn gives you how much delta F depends on
>the inflection temperature of the crystal. It matters if its a true SCor a
>modified SC
.. If it is a true SC and running at 80C, thats about 10 degrees
>below inflection. There will not be a lot of frequency change in that case.
>
>Many (but not all) modern crystal processes tend to age positive. If that is the
>case on these parts, a frequency high is the likely outcome of age out of range.
>Even with a process that has a known tendency, only about 70% of them go
>that direction over long periods of time. Its not a perfect thing
.
>
>Bob
>
>> On Dec 8, 2017, at 2:34 PM, Angus <not.again at btinternet.com> wrote:
>>
>>
>> The 8601 that I have was about 2 deg C off turnover when I got it, but
>> I can't remember what sort or frequency error that caused. The
>> temperature coefficient was terrible with that error.
>>
>> Angus.
>>
>>
>> On Fri, 8 Dec 2017 13:05:14 +0000 (UTC), you wrote:
>>
>>>
>>> Gentlemen,
>>> We have an Oscilloquartz OCXO 8600-3that cannot any longer be adjusted into 5,000,000 Hz.It is about 1 Hz out of 5 MHz and turning coarse/fineadjustment potentiometers cannot bring the frequencyinto its specification.
>>> Oven temperature is about + 80C accordingto the thermistor and the operating voltageis at 24 VDC.
>>> Have Googled but the only thing that turns upis datasheets w/o any details.
>>> Before I take it apart and start lookingfor obviously broken components, isthere anyone that has a CLIP on this unit?
>>> 73
>>>
>>> Ulf Kylenfall - SM6GXV
>>> _______________________________________________
>>> time-nuts mailing list -- time-nuts at febo.com
>>> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>>> and follow the instructions there.
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>
>_______________________________________________
>time-nuts mailing list -- time-nuts at febo.com
>To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list