[time-nuts] Optimal oscillator topology for diffrent frequency range
KA2WEU at aol.com
KA2WEU at aol.com
Mon Feb 6 13:01:28 UTC 2017
That is the pragmatic deflection reply ..... but essentially you are
correct
In a message dated 2/6/2017 7:57:26 A.M. Eastern Standard Time,
kb8tq at n1k.org writes:
Hi
One could easily spend years answering this sort of question. Several
people on the
list *have* done so. Two of them have already tossed up answers.
What are you trying to do?
What is your definition of “low”?
How well equipped are you to test this sort of thing?
How much tweaking are you willing to do?
Do you have a source of (custom) low noise crystals?
Lots of questions and lots of twists and turns in the answers as a result.
Bob
> On Feb 6, 2017, at 4:06 AM, Yeti Yetos <rtoporowski at gmail.com> wrote:
>
> Good morning,
> What's the optimal oscillator topology for low phase noise (low
frequency
> noise and phase noise floor) for 25Mhz/50Mhz/100Mhz frequency range.?
>
> Best regards, Rafal
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list