[time-nuts] No sat positions in LH with Trimble NTBW50AA?

[Jeff AC0C]

I have a '50AA here.  But I don't use any command line options relating to 
box ID.  Just start up LH - LH talks to the box, determines it's a Trimble 
variant, and off to the races it goes.

73/jeff/ac0c
www.ac0c.com
alpha-charlie-zero-charlie

-----Original Message----- 
From: Peter Reilley
Sent: Thursday, January 05, 2017 12:11 PM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] No sat positions in LH with Trimble NTBW50AA?

I tried /rxt but that won't communicate.   Must I put the unit in
Thunderbolt mode?    Is there
a jumper or a command that will do it?   The manual that I have does not
mention different
modes.   It only talks about SCPI.

Thanks,
Pete.



On 1/5/2017 12:41 PM, Mark Sims wrote:
> The Nortel devices can talk either as a Thunderbolt or as a SCPI device. 
> Use it as a Thunderbolt (/rxt).   In SCPI mode the satellite positions are 
> polled for once a minute (at xx:xx:33).  Thunderbolt mode provides much 
> more and better control of the receiver.
>
> ---------------
>
>>   I just got my Trimble NTBW50AA GPSDO up and running with Lady Heather 
>> 5.0.
> However I don't see any satellite data as I do with my Resolution T.   I
> am using
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to 
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>

_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to 
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.