[time-nuts] Thermal effects on cables

Bob Camp kb8tq at n1k.org
Mon Jan 23 17:16:07 UTC 2017


Hi

Nothing is ever simple if you dig deep enough:

http://www.jensign.com/RG58U/

http://www.cliftonlaboratories.com/the_curious_case_of.htm

Bob

> On Jan 23, 2017, at 10:13 AM, REEVES Paul <Paul.Reeves at uk.thalesgroup.com> wrote:
> 
> Hi David,
> 
> Surely the impedance of the cable is only affected by the ratio of the inner conductor and outer conductor diameters modified by the internal dielectric constant, nothing to do with the frequency of operation. You might well have problems converting the larger diameters down to a suitable size for the connectors at the higher frequencies though....
> I thought that the HP cabling for the 8510 series VNAs was air spaced but I might well be wrong - I just tried not to damage them :-)
> Regards,
> 
> Paul Reeves
> 
> -----Original Message-----
> From: time-nuts [mailto:time-nuts-bounces at febo.com] On Behalf Of Dr. David Kirkby (Kirkby Microwave Ltd)
> Sent: 23 January 2017 13:26
> To: Discussion of precise time and frequency measurement
> Subject: Re: [time-nuts] Thermal effects on cables
> 
> On 13 January 2017 at 06:52, Ole Petter Ronningen <opronningen at gmail.com>
> wrote:
> 
>> Hi, all
>> 
>> The question of phase shifts in cables pops up every now and then on 
>> this list - I stumbled across a good table of measured phase shifts 
>> with temperature in different cable types in this paper:
>> http://www.ira.inaf.it/eratec/gothenburg/presentations/ERATEC_2014_
>> PresentationWSchaefer.pdf
>> that I though would be of interest to others.
>> 
>> 
> I've like to know how VNA cables compare. They are expensive enough - a couple of cables around 600 mm long (24") for my VNA are over $5000. They are much larger diameter than normal cables, but much more flexible too.
> The construction is obviously very different. Since mine are designed for use to 26.5 GHz, the internal diameter of the outer conductor can be no more than a couple of mm, yet the overall cable has a diameter of about 15 mm.
> 
> Dave
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.




More information about the Time-nuts_lists.febo.com mailing list