[time-nuts] TAPR GPS Experimenters Kit

[Dave Mallery]

hi

I have been having great results with my M12 and Lady H.  I (foolish me)
had tried to cobble up a Perl program at first...  just browse through some
of the 400+ pages of heathgps.cpp to see why that was a bad idea!  Both my
M12 and my Tbolt are controlled by Heather running on two PI3s.

Now, i would like to get a Lucent RFTG-u REV-0 to run using the PPS from
the M12.  there is a nice PPS interrupt driven arduino sketch on the Sync
Channel Blog.  I'd love to hear from anyone who is also trying this.

73

dave mallery, k5en


On Sun, Jun 4, 2017 at 7:03 AM, Gregory Beat <w9gb at icloud.com> wrote:

> Mark -
> Yes, it does. :-)
> The "S" and "!" menus are the most frequent menus I use with LH.
>
> Jerry is using SynTAC.
> After a few e-mail exchanges, off-list, problem was antenna location.
>
> gb
> ===
> So does Lady Heather... the "S" menu control things like self-surveys,
> entering fixed position coordinates,  and the receiver operating mode.  SN
> will put it in Navigation (3D) mode.  SH will put it in position Hold mode
> (timing mode).
>
> Sent from iPad Air
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/
> mailman/listinfo/time-nuts
> and follow the instructions there.
>



-- 
Dave Mallery, K5EN                 (ubuntu linux 16-10)
PO Box 15                              Ophir,  OR  97464

      linux counter #64628 (since 1997)