[time-nuts] Machining some aluminum help!
jimlux
jimlux at earthlink.net
Thu May 18 17:04:35 UTC 2017
On 5/18/17 9:54 AM, cdelect at juno.com wrote:
> Hi,
>
> I have a square aluminum tube 5" X 5" with a .25" wall it's 8 1/2" long.
>
> I need 20 holes in each end tapped for 4/40 and 1/2" deep.
>
So you're putting 5 holes in each side? in the ends? (i.e. the long axis
of the screw is within the wall?
That's a fairly tricky operation, especially if the tube is standard
extruded tube, because the sides might not be perfectly flat or at right
angles. You're drilling a 0.112 hole in a 0.25" wall, so you've got some
clearance, but I assume you've got a matching cover plate you want to
attach?
How critical is the spacing of the holes?
A good drill press (or vertical mill), and a really good clamping setup,
and "match drill" the cover plate and the tube at the same time.
> This is for a Rubidium project.
>
> The local machine shop want's $360.00!!!!
>
> Anyone have a machining setup that could do the work a bit cheaper?
>
> If not I'll give it a try myself.
>
> Please contact me off list.
>
> Thanks!
>
> Corby Dawson
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the Time-nuts_lists.febo.com
mailing list