[time-nuts] Machining some aluminum help!
cdelect at juno.com
cdelect at juno.com
Thu May 18 20:34:29 UTC 2017
Well that generated a lot of advice and thanks for it!
I think I might do it myself and go with a 1/2" hole depth and 1/4"
threaded depth.
I'll get some of that Aluminum Tap magic, some new taps and new drill
bits.
Good idea about drilling the end plates first and drilling thru to match.
Between the end plate and the tube is a gasket that needs to seal
pressure and moisture tight. That's why I used 5 per side.
Will let you know how it turns out.
Cheers,
Corby
More information about the Time-nuts_lists.febo.com
mailing list