[time-nuts] TruePosition GPS Receiver firmware
Tom Miller
tmiller11147 at verizon.net
Thu May 18 23:08:24 UTC 2017
Maybe I have a problem unit but I measured the supply to the antenna at 3.7
volts. I have a 5 volt antenna and it still receives sats at the lower
voltage. Anyone else check this supply? I wonder if it is a settable
parameter?
Regards,
Tom
----- Original Message -----
From: <ziggy9+time-nuts at pumpkinbrook.com>
To: "Discussion of precise time and frequency measurement"
<time-nuts at febo.com>
Sent: Thursday, May 18, 2017 6:39 PM
Subject: Re: [time-nuts] TruePosition GPS Receiver firmware
> Cool. Should be interesting to see what you find. I've been hacking at the
> VxWorks side of things, off an on,
> but have been distracted by this #wannacry business among other things.
> That TL866 is certainly a good value,
> and it seems to work well.
>
> Looking forward to hearing what you turn up. I'll keep poking at VxWorks
> in the mean time.
>
> On 05/17/2017 08:46 PM, Mark Sims wrote:
>
>> I got in a TL866A programmer with the complete adapter set, pulled the
>> flash chip from my dead TruePosition, and dumped the chip. Success
>> first time! Now to go through the ROM dump and see what hidden goodies
>> there are.
>>
>> A quick look seems to show commands for setting Kalman filter parameters
>> and antenna (?) attenuation. Also a GAIN command (maybe EFC gain or
>> antenna gain). There seems to lots of debug modes in it.
More information about the Time-nuts_lists.febo.com
mailing list