[time-nuts] REF1 standalone issue now
Jerry Hancock
jerry at hanler.com
Wed Nov 15 20:08:40 UTC 2017
OK, go figure, after resetting the loopback jumpers it came alive with a green light, GPS time is ok, still not presenting a satellite on the LH display but it must be seeing something to have the time correct.
Interesting project all along.
> On Nov 15, 2017, at 12:03 PM, Jerry Hancock <jerry at hanler.com> wrote:
>
> I found the write-up on getting 10Mhz out. I added the resistors and cap and brought it out the 15Mhz connector after separating it from the 15Mhz drive.
>
> I booted it up and I have a Yellow No GPS light and a Red Fault. The unit sees the GPS antenna as when I disconnect it the GPS light blinks. I have the interface plug jumper with 2-8 and 3-13 shorted. I’ve seen others that say to take 2 and 3 to 8 and I will try that next. I was very careful in the entire process as it is tough to get the motherboard out of the frame. I am getting 10Mhz on the 15Mhz TP as expected. This is using the original REF1 GPS board.
> Any ideas? Not seeing any sats on lady heather at all. The antenna is known to be good.
>
> Thanks, close but I hope I didn’t do more harm than good.
>
> Jerry
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list