[time-nuts] OCXO Vectron 218Y44442

Mark Spencer mark at alignedsolutions.com
Mon Oct 16 18:29:42 EDT 2017


I've experienced this with products with simple crystal oscillators.   (Ie. Tap or bang the unit to get the oscillator to start oscillating.)

Mark Spencer

mark at alignedsolutions.com
604 762 4099

> On Oct 16, 2017, at 1:10 PM, Vlad <time at patoka.org> wrote:
> 
> 
> Hello,
> 
> I am wandering if anybody observe the behavior for OCXO, when its stop to reproduce the signal, and the only way to return it back to business is little mechanical stress.
> 
> I have TWO of such OCXO. One of them is Austron 11.2 Mhz. And another one is Vectron model 218Y4442 9.8304Mhz
> 
> In case with Vectron, I even disassemble it (to whom who brave here is a pictures):
> 
> http://www.patoka.ca/Vectron-218Y44442/
> 
> Then as I connect it to the PS, I realize it start to reproduce the signal again ! Before this it was nothing ! I tried different PS before to open this "can" as a last resort.
> 
> For the Austron - I didn't disassemble it. Instead I just kick it a little bit. And immediately after that, it start to produce the signal !
> 
> 
> -- 
> WBW,
> 
> V.P.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
> 



More information about the time-nuts mailing list