[time-nuts] Stable32 Input (Multiplier)

Mark Sims holrum at hotmail.com
Sat Aug 11 12:35:15 EDT 2018


Also note that Heather can only get/update the FC value (usually( every two seconds.   Occasionally, due to vagaries in the PRS-10 response timing,  you can see two consecutive values in the log that are not the same.

> 2) Have any of you ever logged the FC values while at the same time taken precision measurements of PRS10 output phase? 

I think that Heather can do that if you use a TICC or counter as an auxiliary input device (/ei command).  In that mode Heather gets the "PPS" and/or "OSC" values from the counter.  Since the FC value is treated as the Heather "OSC" value,  the PPS value would come from the counter (chA on a TICC).   I'll try to do that next week... my TICC and 5370 are doing something else right now.


More information about the time-nuts mailing list