[time-nuts] Receiving the MSF time signal on cheap radio modules
Bob kb8tq
kb8tq at n1k.org
Wed Feb 7 14:31:35 UTC 2018
Hi
Back in the era of VLF disciplined oscillators, carrier phase was the preferred approach.
Getting that to work with 100% AM modulation took some effort ….
Bob
> On Feb 7, 2018, at 2:13 AM, Poul-Henning Kamp <phk at phk.freebsd.dk> wrote:
>
> --------
> In message <CAGJ4F+697SyXwm3yWG-XczN4zF7r2RAmXzAcEm=dhaqBJc_NNw at mail.gmail.com>, "Deirdre O'Byrne" writes:
>
>> MSF disciplined oscillator?! I don't trust these receivers to any better
>> than about the 20ms mark, so such a disciplined oscillator would have quite
>> a long integration time!
>
> It's actually more complicated and better than that.
>
> The low-pass filter dominates, so the falling flank at second N
> depends on the pulsewidth at second N-1.
>
> I can't remember the numbers I got when I "sorted" DCF77 pulses depending
> on the previous pulse being short or long, but it was a fair bit better
> than 20ms.
>
> --
> Poul-Henning Kamp | UNIX since Zilog Zeus 3.20
> phk at FreeBSD.ORG | TCP/IP since RFC 956
> FreeBSD committer | BSD since 4.3-tahoe
> Never attribute to malice what can adequately be explained by incompetence.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list