[time-nuts] Furuno GT-8031 breakout board

Bob kb8tq kb8tq at n1k.org
Fri Feb 16 17:55:58 UTC 2018


Hi

Even more exciting, some of the “M12 like” devices are close, but not exact copies of the
M12 command set. Your GPSDO may be fine with the differences on this device, but not
so happy with the differences on some other device. 

Bob

> On Feb 16, 2018, at 12:50 PM, Mark Sims <holrum at hotmail.com> wrote:
> 
> No, the Tbolt does not have a separate receiver board... plus its' GPS is rather special... the RF chain is locked to the OCXO so it does not produce any sawtooth error.
> 
> The Lucent KS firmware expects the GPS to support the older 6/8 channel messages.   The newer 12 channel  messages are different.
> 
> BTW, I just did a Motorola M12 to Adafruit pinout board.  The M12 form factor and pinouts are also used by a lot of other timing receivers.  Why Adafruit?  Because it is breadboard friendly,  has enough pins for all the signals that one expects,  and my GPS to RS-232 adapter board has an Adafruit connector on it.
> 
> ----------------
> 
>> Never having opened my TBolt, are the GT-8736 boards of use to replace the aging and partly deaf receiver in that? Or for a KS-24019?
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.




More information about the Time-nuts_lists.febo.com mailing list