[time-nuts] minimalist sine to square

Mark Sims holrum at hotmail.com
Fri Jan 19 20:25:10 EST 2018


Tom,

Hook the 53132A calibrator that I sent you and check one of the calibrator outputs for signal goodness.  It uses the sine-square circuit in the LPRO-101 manual (input cap connected to center of a 39K/39K voltage divider connected to a 74HC gate (74AC gates have some advantages and disadvantages here).    It's the simplest excellent bang-for-the buck squarer (three passives and a single CMOS gate).   You can use single-gate chips.   

I'm using the same circuit on the LPFRS/LPRO/OCXO interface board.  I'm also pondering doing a small board with a sine/square wave input,  square wave output, PICDIV, PICPET, and a 10 MHz square to sine filter.

Attached is the xDEV plot of the calibrator (using TAPR-TICC, TADD2-mini, 5071A reference).
-------------- next part --------------
A non-text attachment was scrubbed...
Name: cal5.gif
Type: image/gif
Size: 50007 bytes
Desc: cal5.gif
URL: <http://lists.febo.com/pipermail/time-nuts_lists.febo.com/attachments/20180120/4611d2a1/attachment.gif>


More information about the time-nuts mailing list