[time-nuts] Slightly OT: interest in a four-output, ultra-low jitter, synthesizer block?
jimlux
jimlux at earthlink.net
Thu Jan 25 20:44:06 UTC 2018
On 1/25/18 12:12 PM, wb6bnq wrote:
> Hi John,
>
> Thanks for the response. Here is my 2 cents:
>
> Well, due to the level of difficulty in chip mounting, I would prefer to
> see a complete project. I.E., power supply for a single input of 12
> volts and regulators the necessary chip values, proper input protection
> for the 10 MHz input level and single ended outputs of the appropriate
> levels (I am assuming more than 3 volts) or an amplifier stage for
> arriving at such. Equally have RF connectors (SMA would be good) on the
> board perhaps.
The eval board for $200 might be a solution for that need: SMA
connectors all around, runs off 5V from USB.
>
> Of course as cheap as possible, hi hi.
Oh, well, $200 might be cheaper than cobbling together
packaged/connectorized parts though.
A carrier board arrangement
> would be useless to me. My application would be to provide signals for
> things like my Quicksilver SDR receiver, among other uses.
>
> If you are interested, I can show you a nice little ABS (I think) box
> that has EMI built-in that I used for a project that should be more than
> large enough for your needs.
>
> Than
More information about the Time-nuts_lists.febo.com
mailing list