[time-nuts] ✘NEO-M8N vs. NEO-M8T

ew ewkehren at aol.com
Mon May 21 09:00:27 EDT 2018


Should say 1.7 nsec we also plan to use the GCLK output for what I call a GPS PLL we have done it successfully with low cost u-blox with  E-11 frequency results.
Bert Kehren
 
In a message dated 5/21/2018 7:49:20 AM Eastern Standard Time, time-nuts at febo.com writes:

 
  
Our answer was real time correction, see attached, just received boards for Furuno BT-87, with a specification of 1.7 msec. saw tooth, we do not plan on any additional processing.We have experience with Ublox up to 7 but have spend no time on 8, waited on availability of the 87. Digi Key wants $ 100 but found them half that price in Germany. Has any body found a lower price in the US?
Bert Kehren
 
In a message dated 5/20/2018 11:12:05 PM Eastern Standard Time, gem at rellim.com writes:

 
 Yo Mark!

On Mon, 21 May 2018 03:04:23 +0000
Mark Sims <holrum at hotmail.com> wrote:

> The sawtooth value is in the 0x0D-0x01 (TIM-TP) message. Third
> value, called qErr. 32-bit dword. In picoseconds.

How do I feed that into my TICC in real time?

RGDS
GARY
---------------------------------------------------------------------------
Gary E. Miller Rellim 109 NW Wilmington Ave., Suite E, Bend, OR 97703
gem at rellim.com Tel:+1 541 382 8588

 Veritas liberabit vos. -- Quid est veritas?
 "If you can’t measure it, you can’t improve it." - Lord Kelvin
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there._______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there. 



More information about the time-nuts mailing list