[time-nuts] ✘NEO-M8N vs. NEO-M8T

[Bob kb8tq]

Hi

You have always been able to poll the time offset message on any of the uBlox 
modules. Getting that message to auto repeat was the traditional issue on there
earlier products. A serial dump would tell you if u-center is getting the information 
by polling or not. 

Bob

> On May 21, 2018, at 11:05 AM, Oleg Skydan <olegskydan at gmail.com> wrote:
> 
> Hi!
> 
> From: "Bob kb8tq" <kb8tq at n1k.org>
>> Not by default You go through the 390 pages of their manual and eventually
>> find the bits to turn this and that on. When you do, those magic bits will enable
>> the data on a T version and will not enable it on a non-T version. At least that’s
>> the way it’s worked since the LEA-4T …
> 
> You can use uBlox u-center software to enable and disable messages you need, the configuration can be saved.
> 
> It looks like the NEO-M8N (non timing one) module should provide sawtooth correction data (at least the manual does not say that TIM-TP message is available on timing modules only). I was able to enable TIM-TP message on the older NEO-6M. You can test if it works with the help of u-center.
> 
> Best!
> Oleg 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.