[time-nuts] Distribution amplifier for 10MHz and 1 pps
Paul Bicknell
paul at bicknells.f2s.com
Sat Mar 16 23:37:41 UTC 2019
Hi just a thought
Video distribution amps for analogy video have been talked about
Video is typically 7 mhz so they should work OK
The input signal is looped to each amplifier input and terminated on the
last amplifier input with a resistor for video it is 75 ohm but for a
reference signal it is 50 ohm
The amp output is normally fed via a 75 ohm resister so this will have to be
changed internally for a 50 ohm
The phase change through the amps will have to be measured but if all amps
are the same and only signals from the amps are used all phases differences
between the different outputs should be very low and they might not even be
easily measured
Cct diagrams and descriptions are available in the older BATC CQ TV books
Regards Paul
-----Original Message-----
From: time-nuts [mailto:time-nuts-bounces at lists.febo.com] On Behalf Of
Attila Kinali
Sent: 16 March 2019 20:27
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] Distribution amplifier for 10MHz and 1 pps
On Sat, 16 Mar 2019 18:01:36 +0000 (UTC)
Taka Kamiya via time-nuts <time-nuts at lists.febo.com> wrote:
> But how do I do this on 10MHz side? I'd like to have minimal distortion
> (sine wave) and high isolation. I acquired a few signal splitter and
> monolithic amplifiers. Split first and amplify? Amplify first and
split?
> Remember it's only 2 to 3 channels. Amplifier module has too much gain,
so
> I'll probably have to use attenuators.
Amplify - split - amplify.
The first amplifier is there to compensate for the loss of the splitter.
You might want to add additional attenuators between the splitter
and the output amplifiers for increased isolation between channels.
> Have anyone run into this kind of thing? Is there an existing design?
> Anything anyone would like to share?
Anders Wallin has a design that seems to work very well:
http://www.anderswallin.net/2017/01/frequency-distribution-amplifier-2017-01
/
(His blog is worth watching, he does some very nice electronics)
Attila Kinali
--
<JaberWorky> The bad part of Zurich is where the degenerates
throw DARK chocolate at you.
_______________________________________________
time-nuts mailing list -- time-nuts at lists.febo.com
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2016.0.8048 / Virus Database: 4793/15884 - Release Date: 08/14/18
Internal Virus Database is out of date.
More information about the Time-nuts_lists.febo.com
mailing list