[time-nuts] 5 Mhz to 10 Mhz and 25 Mhz

[Bob kb8tq]

Hi

A lot depends on what your end use is and what you have to work with. There are
Altera FPGA boards that have built in PLL’s that will accept a 5 MHz input. You can 
generate just about anything with them. 10 and 25 MHz (plus 1 pps) with multiple 
outputs of each would be pretty easy. Phase noise / jitter might not be super duper, 
but how good is your source? What are you driving? It may well be good enough.

Bob

> On Sep 8, 2019, at 6:02 AM, Paul Bicknell <paul at bicknells.f2s.com> wrote:
> 
> Dear all
> 
> Can any one point me in the direction of a circuit that can convert 
> 5 Mhz signal to give me 2 outputs one at 10 Mhz and another at 25 Mhz
> 
> 
> Regards Paul B
> 
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com
> To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
> and follow the instructions there.