[time-nuts] 15Mhz in 10MHz out?

[paul swed]

David
Its been quite a while but either 5 or was it 10 MHz comes from the OCXO.
There were pictures of the tap off points. So it could be a bit easier for
you grab that 5 or 10 MHz and run it through the chip to multiply. If 10
MHz then just filtering as I recall.
Regards
Paul.

On Wed, Sep 18, 2019 at 5:12 AM David C. Partridge <
david.partridge at perdrix.co.uk> wrote:

> Having seen the recent discussion of the NB3N502 and other PLLs for
> frequency multiplication.  I'm wondering if anyone knows of a similar
> *small* IC that will convert 15MHz to 10MHz ?
>
> Why? My current modifications to the KS24361 output 10Mhz signals
> regardless
> of whether the unit has lock.   ISTR that the original 15MHz output was
> only
> enabled when the unit had lock.   I'd like to redo the PCB which I put in
> place of the 15MHz band-pass filter and replace it with one that takes
> 15Mhz
> an outputs 10Mhz.
>
> Thanks
> David
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com
> To unsubscribe, go to
> http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
> and follow the instructions there.
>