[time-nuts] time-nuts Digest, Vol 190, Issue 5

[Dave B]

Has anyone found schematics for the Mean Well supplies? I have a couple of 15V 7A ones that will adjust down to 14.1 and I?d like to get them down to the 12-13.8 range. 

Steve
WB0DBS


If they have remote sensing, you can do stuff with that too.  Else, trace out the cct around the voltage setting pot, there will probably be some fixed resistor at each end, one or other will move the high or low point as you need.  (Lower values = greater adjustment range.)

BUT!  Note, that though you can usually lower the output voltage, you will not get any extra current as that is limited by the transformer design and capabilities.

Similarly, if you raise the output voltage, you will need to de-rate it's current output ability, so as not to exceed it's power capability.   Don't go too far from nominal (especially lower voltage) as the control loop regulation may misbehave under some load conditions. 

In any case, 14.1 is OK for most "12V" kit, especially anything that is intended for use in a vehicle, where the engine running battery voltage can often be up near 15V with modern vehicles and battery chemistry.

73.

Dave G0WBX.


On 03/05/2020 17:00, time-nuts-request at lists.febo.com wrote:
> Has anyone found schematics for the Mean Well supplies? I have a couple of 15V 7A ones that will adjust down to 14.1 and I?d like to get them down to the 12-13.8 range. 
>
> Steve
> WB0DBS

-- 
Created on and sent from a Unix like PC running and using free and open source software: