[time-nuts] OCXO Support Board
ew
ewkehren at aol.com
Wed May 13 16:12:41 UTC 2020
You give away your age, was there did a lot of it and off to the repro shop and than the board manufacturer. All local in Houston.
Bert Kehren
In a message dated 5/13/2020 10:39:48 AM Eastern Standard Time, wes at triconet.org writes:
Thank you to all who have written, on and off list, with offers of boards and
advice on how to make my own. Much appreciated.
I think I'm on to one that meets my fairly simple needs and uses through-hole
components. I have done SMT construction in the past but things have shrunk in
size by an order of magnitude since then it seems. (I can remember laying out
boards by hand, taping up the artwork 4:1, reducing it photographically,
exposing and etching boards. So today's technology is magical.)
Many of you are doing some awesome work. Well done.
Wes N7WS
_______________________________________________
time-nuts mailing list -- time-nuts at lists.febo.com
To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list