[time-nuts] Quartzlock E10-MRX

[rfnuts]

If it works, don't try to fix it.
In the datasheet
https://quartzlock.com/userfiles/downloads/datasheets/e10-mrx(2)(1).pdf
there is no cooling requirement specified.
I would assume that it is usually mounted on a PCB which adds some 
cooling though not terribly much.
After 1 hour the case temperature should be about 45 Deg. C at 25 Deg. 
ambient.

Adrian

Am 01.09.2020 um 07:15 schrieb Richard Katsch:
> Hello All,
> I have acquired a Quartzlock E10-MRX Rb 10 MHz standard. It appears to lock
> and produce a nice sine wave that stays in phase with my Trimble Tbolt for
> a time which exceeds my attention span!!!
> It does however get hot in operation. As this is my first experience with a
> Rb standard I don’t know whether this is normal or indicates that I need a
> heat sink.
> Any comments would be appreciated.
> Regards
> Richard Katsch
> VK2EIK
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com
> To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
> and follow the instructions there.
>