[time-nuts] Re: PN9000 software?

[Jorge Gomez]

There is another problem besides the software, if I remember correctly the
FFT card resides on the computer, not on the PN9000 box.
Jorge.

On Sun, Nov 21, 2021 at 9:49 AM AC0XU (Jim) <James.Schatzman at ac0xu.com>
wrote:

> I recently purchased an Aeroflex PN9000 system with the correct modules
> for doing phase noise measurements. However, I haven't been able to figure
> out how to get the software for this system. The only digital interface is
> GPIB.
>
> I believe that from the factory the system came with a Dell workstation
> with a GPIB card and an A2D card. I haven't seen any of these workstations
> or the software for sale. I have other GPIB and A2D cards, but no software.
>
> If I can't get the software, then reverse-engineering the system seems
> possible theoretically but could be difficult, especially since there does
> not appear to be a service manual or any kind of GPIB ICD for the system.
>
> Advice?
>
> Thanks- Jim
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com -- To unsubscribe send
> an email to time-nuts-leave at lists.febo.com
> To unsubscribe, go to and follow the instructions there.
>