[time-nuts] TimeHat

[Robert DiRosario]

On the Raspberry Pi TimeHat is there output to the HDMI connector, or is 
it configured to just use a serial console?
I'm using the preconfigured SDHC card, so the software should be fine.  
If I swap out the SDHC card with a different one the systems boots fine, 
so the hardware works.

With the card with the software there is never any output to the HDMI 
connector.

Based on the LED on the GPS module it's locking up on the GPS signals 
just fine.  After the initial lockup, it locks up again in only a few 
seconds after a power cycle.

Robert