[time-nuts] Re: James Miller/Brooks Shera 10 MHz GPSDO

[Askild]

Hi Merv,

I don't know about this GPSDO design, but the HP 10811 OCXO has a coarse
frequency adjustment capacitor on top of it.
You should be able to adjust this, so the EFC tuning voltage are again
inside the range of the potentiometer/DAC of the GPSDO.

Regards,
Askild



On Mon, Aug 29, 2022 at 5:56 AM Mervyn Thomas via time-nuts <
time-nuts at lists.febo.com> wrote:

> Hi All,
>
> I'm new to time nuts but here goes.
>
> I built a GPS disciplined  10MHz osc about 15 + years ago.  It uses an
> HP 10811 D/Oven Oscillator and the Brooks Shera PCB and software V402N.
> The physical construction article was per James Miller G3RUH.
>
> This unit has worked flawlessly for all these years but now is unable to
> hold the freq to precisely 10MHz - it is constantly .29 to.60 Hz high.
> The DAC output which controls the EFC into the osc outputs a negative
> only adjustable voltage between -3v down to 0V and is settable by
> varying a 10K potentiometer.  The Osc. now needs abouit +0.46V to bring
> it down to 10MHz but the DAC does not seem able to output a positive
> voltage.  The DAC is an AD1861 (obsolete) and has a +5V applied to pin
> 16 and a -5V applied to pins 1 and 8.
>
> My first reaction was the HP osc. had reached the end of it's life but
> the datasheet states the EFC control voltage can be between a plus 5V
> and a minus 5V which varies the freq by 1Hz so it seems it is just over
> half way through it's life.
>
> I feel the Brooks s/ware would have provided some method to ensure the
> DAC output could be adjusted to swing the full full 5V or at least 3V?
> I have the source code but I'm no programmer so would appreciate any
> help someone can provide please.
>
> 73 de Merv  VK6BMT
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com
> To unsubscribe send an email to time-nuts-leave at lists.febo.com