[time-nuts] Re: Trimble Palisade problems

[Björn]

Steve,

Can you upload a current almanac to the receiver from the win software?

/Björn 

Sent from my Phone

> On 24 Sep 2022, at 12:39, Steve Platt via time-nuts <time-nuts at lists.febo.com> wrote:
> 
> On 23/09/2022 20:54, Hal Murray wrote:
>> That combination seems strange.  After several years, the almanac is way out
>> of date.  So how does it know where to look for satellites?  Or, if it has an
>> up-to-date almanac, it's listening to satellites.  ??
>> 
>> What are you using for software to show the satellites?  Did anything change
>> in that area?
>> 
>> Have you tried Lady Heather?
>> 
>> Can you do a system reset so it starts clean?
>> 
>> Are the 10 MHz and PPS out accurate?
> Thanks for the reply Hal, to answer your queries briefly: there are no longer any signals being received!
> 
> Software-wise, I had been using NTP to get time from the unit, for years.  Since the problem, I've been monitoring the TSIP on port B using GPSD (I run Linux) however, in desperation(!) I booted Windows and am now using PalisadeMonitor.exe on port B, which confirms that there are no signals received (even several days after power-up).
> 
> I've tried issuing "cold start" and "factory reset" to no avail.  I did, on the bright side, manage to upgrade the firmware from 7.10 to 7.12 (and it still booted ok!) but no signals are being received, therefore no PPS output.
> 
> Steve
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com
> To unsubscribe send an email to time-nuts-leave at lists.febo.com