[volt-nuts] Keithley 2001 Multimeter Fault
Mark Sims
holrum at hotmail.com
Sun Mar 7 04:50:21 UTC 2010
Check the input voltage to the regulator. If it is over 7V then you can use a normal 3 terminal regulator (7805, LM340, etc). The LM1086 has a bit less dropout than these.
I have seen lots of designs where LDO regulators were used when the input voltage was high enough for a regular regulator.
------------------------
I hadn't realised the LM2940CT-5 was so dependant on the output capacitor
capacitance and ESR for stability until I tested one just now. Can anyone
recommend an upgrade?
_________________________________________________________________
Hotmail: Trusted email with Microsoft’s powerful SPAM protection.
http://clk.atdmt.com/GBL/go/201469226/direct/01/
More information about the volt-nuts
mailing list