[volt-nuts] PCB Artist

[David C. Partridge]

I've used iTead studio with success. very reasonable prices and good work.  Whether I'd use them for 4 or more layers I'm not sure, but for 2 layer they seem fine.

Dave

-----Original Message-----
From: volt-nuts [mailto:volt-nuts-bounces at febo.com] On Behalf Of Randy Evans
Sent: 14 December 2016 00:05
To: Discussion of precise voltage measurement
Subject: Re: [volt-nuts] PCB Artist

KiCad looks very good and I downloaded it to try it out.  However, does anyone have a good, low-cost PCB fab house to recommend?  I am designing a voltage reference programmable fro 0 to 10 volts with a LTZ1000 reference and settabiltiy of 0.1ppm and I need a PCB fabbed.

Thanks,

Randy Evans AE6YG