[time-nuts] New GPS Signals
magnus at rubidium.dyndns.org
Wed Mar 25 13:29:43 EDT 2009
brooke at pacific.net wrote:
> There are three new civilian GPS signals, L1C, L2C and L5.
> The original civilian signal, L1 is at 1575.42 MHz (154 * 10 * F0,
> F0=1.023 MHz).
f0 should really be set to 10,23 MHz.
> L1C is at the same frequency as L1 but uses the code like Japan.
It looks similar to L5 actually, but coordination with Galileo, QRSS,
Glonass and Compass is underway.
> The new L2C signal is at 1227.60 MHz (120*10*F0). Allowing for path
> length corrections.
> The new L5 signal is at 1176.45 MHz (115*10*F0). This is intended for
> aircraft safety. It also has the largest frequency difference to L1 so
> should also be the best for determining the path length through the
> ionosphere/troposphere allowing for a more accurate time fix
Currently we have these signals:
L1 C/A (from all current sats)
L1 P(Y) (from all current sats)
L1 M (from GPS-IIR(M) sats)
L2C (from GPS-IIR(M) sats)
L2 P(Y) (from all current sats)
L2 M (from GPS-IIR(M) sats)
In a couple of weeks we can also expect the first transmission of
L5C (from GPS-IIR(M)20 sat)
It will be years before we see L1C (from GPS-III sats).
> I'm hoping my Polaris Guide receiver will get upgraded firmware to get
> these signals as well as have WAAS added. See:
> Are there any new timing GPS receivers that take advantage of the new
There is a few, but they are not in wide spread. You need to look into
the geodestic receiver market. Trimble amongst others have receivers
More information about the time-nuts