[time-nuts] Efratom LPRO101 in a Tek TM500 plug-in housing?

[Mark Sims]

Yes,  I have built one.

I mounted the LPRO on an "L" shaped piece of aluminum .065 sheet the width of the LPRO.  The large end of the "L" is bolted to the LPRO baseplate and TM500 prototyping module circuit board with threaded standoffs (jack screws)  The small end of the "L" is bolted to the TM500 module top plate with 12 countersunk screws and thermal compound.   

There are two very small and thin fans mounted on the back of the TM500 circuit board on small standoffs.  They blow towards the baseplate (though the holes in the prototyping board).


 		 	   		  
_________________________________________________________________
Hotmail: Trusted email with powerful SPAM protection.
http://clk.atdmt.com/GBL/go/177141665/direct/01/