[time-nuts] DPLL for 10MHz

[Tom Knox]

I do not know if this is the type of solution you were looking for but Wenzel builds a fantastic LNPLL.

Thomas Knox



> Date: Mon, 7 May 2012 16:11:13 -0500
> From: docdailey at gmail.com
> To: time-nuts at febo.com
> Subject: Re: [time-nuts] DPLL for 10MHz
> 
> Regarding my abilities.. regarding electronics... poor soldering is about
> my limit... through hole only.   That is why I was hoping there was some
> off the shelf method that I could wire up with 10 MHz in from the gspdo and
> from the oscillator then wire up the EFC volatge and set the required
> parameters and it would adjust my oscillator to the same frequency as the
> GPSDO.  Sounds simple enough to me.  but apparently not.  I guess I need to
> figure out how to do this electronics stuff...incidentally avoidance of 1)
> foreign languages, 2) drafting and 3) electronics is why I chose to become
> a chemical engineer.. hi hi.  I once accidentally signed up for a physics
> lab that involved electronics... made it through the first lab period.. was
> like a fish out of water... walked immediately to administration and
> dropped it.  Oscilla-what I said as I skipped out of there.  It was all
> electrical engineers.
> 
> 
> -- 
> Doc
> 
> Bill Dailey
> KXØO
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.