[time-nuts] Trimble Resolution SMT - good/bad/indifferent?
SAIDJACK at aol.com
SAIDJACK at aol.com
Thu May 10 19:55:52 UTC 2012
Ok,
I figured out that the unit fluke.l sells is running firmware to emulate
the Motrola M12+ receiver or similar. So WinOncore 12 does work, and I can
get the following receiver ID:
COPYRIGHT 2008 Trimble Navigation Ltd.
SFTW P/N # 0000
SOFTWARE VER # 0.03.0
SOFTWARE REV # 00
SOFTWARE DATE 04/27/2009
MODEL # 3011
HDWR P/N # 0000
SERIAL # 20393136
MANUFACTUR DATE 06/05/2009
OPTIONS LIST 0000
Does anyone know what the command is to configure this for NMEA or TSIP?
Thanks,
Said
In a message dated 5/10/2012 12:15:56 Pacific Daylight Time,
SAIDJACK at aol.com writes:
Hi Holrum,
how do you re-configure the SMT unit? Using Trimble GPS studio?
Thanks,
Said
In a message dated 5/9/2012 15:17:21 Pacific Daylight Time,
holrum at hotmail.com writes:
I have it running now. It turns out that the units from fluke.l come
shipped with TEP format messages enabled (it outputs @@Cf on power up).
You
have to re-configure them for TSIP protocol and save the configuration
back
to the unit. Hope to have Lady Heather taking to it. It does come up
with
several of the messages working. Sat info is not one of them.
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list