[time-nuts] Trimble Resolution SMT - good/bad/indifferent?

[Azelio Boriani]

What's bad with the Motorola binary protocol? In my opinion it is superior
to the NMEA one...

On Thu, May 10, 2012 at 9:55 PM, <SAIDJACK at aol.com> wrote:

> Ok,
>
> I figured out that the unit fluke.l sells is running firmware to  emulate
> the Motrola M12+ receiver or similar. So WinOncore 12 does work, and I  can
> get the following receiver ID:
>
> COPYRIGHT 2008 Trimble Navigation Ltd.
> SFTW P/N # 0000
> SOFTWARE VER # 0.03.0
> SOFTWARE REV # 00
> SOFTWARE DATE  04/27/2009
> MODEL #    3011
> HDWR P/N # 0000
> SERIAL #   20393136
> MANUFACTUR DATE  06/05/2009
> OPTIONS LIST    0000
>
> Does anyone know what the command is to configure this for NMEA or  TSIP?
>
> Thanks,
> Said
>
>
> In a message dated 5/10/2012 12:15:56 Pacific Daylight Time,
> SAIDJACK at aol.com writes:
>
> Hi  Holrum,
>
> how do you re-configure the SMT unit? Using Trimble GPS  studio?
>
> Thanks,
> Said
>
>
> In a message dated 5/9/2012 15:17:21  Pacific Daylight Time,
> holrum at hotmail.com writes:
>
> I  have  it running now.  It turns out that the units from fluke.l come
> shipped  with TEP format messages enabled (it outputs @@Cf on power  up).
> You
> have  to re-configure them for TSIP protocol and save  the configuration
> back
> to the  unit.  Hope to have Lady Heather  taking to it.  It does come up
> with
> several of the messages  working.  Sat info is not one of   them.
>
>
> _______________________________________________
> time-nuts  mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the  instructions there.
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>