[time-nuts] [Bulk] Z38xx rack mounts

J. L. Trantham jltran at att.net
Wed Oct 22 20:22:56 EDT 2014


Being lazy, I used two aluminum angle brackets, one 'on top' and one 'on the bottom', mounted to a 19" rack, spaced vertically so that a Z3816A would just fit between them.  Then I used the Z3816A's mounting screws to 'mark' the brackets, drilled 8 holes, 'tapped' the holes so that the threads of the Z3816A mounting screws fit and mounted two Z3816A's, side by side, in a 19" rack.  Functional and it doesn't look too bad either.

Good luck.

Joe

-----Original Message-----
From: time-nuts [mailto:time-nuts-bounces at febo.com] On Behalf Of Dave M
Sent: Wednesday, October 22, 2014 3:45 PM
To: FEBO Time Nuts
Subject: [Bulk] [time-nuts] Z38xx rack mounts

I have a couple questions regarding the Z38xx type units.  I have a Z3801A, and a couple other modules that don't need a full 19" rack space.  The Z38xx units are 11" wide (10-9/16" mounting centers) , and obviously are not suitable for a standard 19" rack cabinet.

Looking in the Z3801A manual, I see that the rack trays that these units are mounted in are 28.5" wide, with a dual mounting shelf so that two GPS units can be mounted side-by-side.  Were the racks for these units custom built by Motorola and/or Symmetricom?  Where in the civilized world might these cabinets and mounting shelves be found and purchased (preferably surplus)? 
I've searched Google until my eyes are crossed, but nothing shows up.  Maybe I'm not using the right search terms?  Don't know.

I guess I could destroy an old rack cabinet and fabricate something that would fit the equipment, but I'd prefer to buy one (assuming that it doesn't approximate the cost of a new SUV).

Cheers,
Dave M
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.




More information about the time-nuts mailing list