[time-nuts] minimalist sine to square

Bruce Griffiths bruce.griffiths at xtra.co.nz
Sun Jan 21 15:27:13 EST 2018


I wonder what the timing jitter is like.

It may be useful to measure it along with its additive PN.

Bruce

> 
>     On 22 January 2018 at 07:31 Robert LaJeunesse <lajeunesse at mail.com> wrote:
> 
>     How about using a single 8-pin DIP IC that is under $2.50? The Microchip MIC4422AYN "gate driver" takes a 3.3V signal in and produces a fast rail-to-rail output swing, with a 4.5V to 18V supply range. Typical output resistance is sub 1 Ohm, so not a problem driving a series back-terminated 50 Ohm load. Note the 4422's rise and fall times are specified with a 10,000pF load, given the primarily resistive load in this case the rise and fall should be sub 10 ns (per p.5 of the data sheet). But do use beefy lo-Z traces and hefty broadband supply bypassing, the MIC4422 can pump up to 9A into its intended load.
> 
>     Bob L.
> 
>         > > 
> >         Sent: Saturday, January 20, 2018 at 2:43 PM
> >         From: "Jerry Hancock" <jerry at hanler.com>
> >         To: "Discussion of precise time and frequency measurement" <time-nuts at febo.com>
> >         Subject: Re: [time-nuts] minimalist sine to square
> > 
> >         ...
> > 
> >         Now that I had the input conditioned, I need to drive a 50ohm load with the signal coming from the PICDIV. Can someone point me at a circuit using transistors and 10V if possible?
> > 
> >         I am trying to duplicate one channel of the TADD2 so I can bring 10Mhz down to 10Khz.
> > 
> >         Thanks
> > 
> >         Jerry
> > 
> >     > 



More information about the time-nuts mailing list