[time-nuts] inexpensive fiber optic distribution
Mark Sims
holrum at hotmail.com
Thu Mar 21 16:29:58 UTC 2019
The "personality" for these modules is stored in a bog standard 3.3V 256 byte I2C EEPROM (address 0xA0). The I2C bus is n the connector. An Arduino can reprogram that memory. For the simplest case you just change the vendor ID info. I think the kilobuck level programmers is just a simple I2C interface with some software that knows what to change.
--------------
>As far as the reprogramming goes (another comment on the list) - I
understand that is to make the unit have some particular flavor
SFP-wise. If you were plugging them into a Cisco switch and all you had
was ones configured for Juniper switches, then you'd want to do that. At
the multikilobuck level to do this, you'd need a LOT of them to make it
worthwhile.
More information about the Time-nuts_lists.febo.com
mailing list