[time-nuts] Dead 5061B
cdelect at juno.com
cdelect at juno.com
Mon Nov 4 16:00:45 UTC 2019
Jim,
The ion pump supply is fine if the Cs oven reading is OK. A zero reading
is fine on the Ion pump current.
Yes do check the ionizer filament continuity and if its OK check the
voltage across it. Should be around 1 VDC.
If all that looks good pull J1 off A7 and feed it into a high impedance
voltmeter and redo the low freq. test.
If it looks good You might have a bad A7.
Cheers,
Corby
More information about the Time-nuts_lists.febo.com
mailing list