[time-nuts] GPS antenna splitter recommendation? (John Ackermann N8UR)

Chris Quayle syseng at gfsys.co.uk
Thu Apr 30 17:11:55 UTC 2020


On 04/30/20 17:00, time-nuts-request at lists.febo.com wrote:
> Re: GPS antenna splitter recommendation? (John Ackermann N8UR)

Usually a lurker here, but a couple of points. The best splitters are
those designed for the task, such as the HP or symmetricom 4 way
boxes seen from time to time on Ebay, though typically expensive.

There are various issues:

1) The gps receiver will throw a fault if the antenna dc load is
missing, though a simple fixed resistor load takes care of that.

2) The commercial units provide low noise gain to make up for the
loss in a passive output splitter.

3) Typically, only one of the receiver ports is specified to provide
the antenna power and also internal preamp power, with dc isolation
for the rest.

Can't see that a passive splitter would be an ideal solution without
serious hackery, when you could build one using the cheap uhf amp
gain block pcb's widely available now...

Regards,

Chris






More information about the Time-nuts_lists.febo.com mailing list