[time-nuts] PLL suggestions
Bob kb8tq
kb8tq at n1k.org
Thu Jan 2 14:55:48 UTC 2020
Hi
A low phase noise VCXO is going to be up in the vicinity of $20. An MCU that will do the
loading stuff is in the << $1 range. BOM wise, the MCU is round off error. Code wise, the
firmware is “high school project” level stuff.
Bob
> On Jan 2, 2020, at 9:26 AM, Dan Kemppainen <dan at irtelemetrics.com> wrote:
>
> Hi All,
>
> Just to clarify, the PLL we're looking for only needs to do the 10 -> 125MHz. The 125 ->MHz 3.125GHz is in a separate device with it's own PLL. I have some, but not a lot of control over that. The goal here is to provide a good source for the 125Mhz, for not a lot of board space and not a lot of BOM cost.
>
> Again, I apologize as this is a bit vague. Basically we're trying to provide a "as good as reasonably possible" 125Mhz source from a VCXO, in a relatively small (1 to 2 sq inches) board space, for not a lot of cost ($25 to $50 range).
>
> Anyway, There have been some good suggestions here, and a few off line also.
>
> Thanks!
> Dan
>
>
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com
> To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list