[time-nuts] GN-GGB0710 GNSS Antenna
djl
djl at montana.com
Mon Feb 25 01:01:04 UTC 2019
Probably tapped for 1/2" pipe thread.
Don
On 2019-02-24 12:40, Ben Hall wrote:
> Good evening all,
>
> After almost a month in transit, my GN-GGB0710 GNSS antenna arrived
> from the auction site "we all know and love." ;)
>
> Unit was not tapped to a proper 5/8"-11 TPI thread. A standard 5/8-11
> bolt went in maybe two full threads. I modified an old tap I had in
> the drawer into a 5/8"-11 bottom tap and cleaned it up. Best I can
> tell, the thread cut by the manufacturer was slightly tapered.
>
> I wasn't thrilled with the seal around the edge. Because it's flat,
> some water might wick in, so I ran a quick bead of seal around both
> the top and bottom end of the blue rubber seal.
>
> Unit seems to work well. It's not mounted to the top of my antenna
> pole, about 16 feet up from the ground, where it can see a pretty much
> unobstructed view of the sky. All the GPS units on it thru the
> splitter are getting excellent signal.
>
> Now to wait until uBlox releases the ZED-F9T dev board. I did get a
> response back from uBlox sales to my work e-mail address (which is a
> very large organization) saying it's still in development with a
> target release date of May or so...
>
> thanks much and 73,
> ben
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com
> To unsubscribe, go to
> http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
> and follow the instructions there.
--
Dr. Don Latham AJ7LL
PO Box 404, Frenchtown, MT, 59834
VOX: 406-626-4304
More information about the Time-nuts_lists.febo.com
mailing list