[time-nuts] Mounting thread on TopGNSS GN-GGB0710
John Ackermann. N8UR
jra at febo.com
Wed Oct 30 11:39:40 UTC 2019
The limited knowledge I've obtained about survey antenna is that almost all use a straight 5/8-11 thread. There are various 5/8 adapters available. I use one to 1/4-20 to mount the antenna on a camera tripod.
On Oct 30, 2019, 3:17 AM, at 3:17 AM, Hal Murray <hmurray at megapathdsl.net> wrote:
>
>> I have two of these. They are both 5/8-11, however they were both
>tapered.
>> The taper can be removed with a hand tap.
>
>Are tapered threads used for something other than pipes?
>
>
>> The ones I���ve seen all thread fine onto the standard survey poles.
>I believe
>> that is a 5/8-11 thread.
>
>Do survey poles have a tapered thread, or are the threads short enough
>not to
>encounter the tapered part of the hole? Google found lots of adapters.
> None
>of the threads looked tapered.
>
>I'm not a machinist (but my dad was). Wiki says it's common to start
>with a
>tapered tap because they are easier to get started, then follow up with
>a
>bottoming tap if necessary. Did they just forget that step for a batch
>of
>antennas?
>
>
>--
>These are my opinions. I hate spam.
>
>
>
>
>
>
>------------------------------------------------------------------------
>
>_______________________________________________
>time-nuts mailing list -- time-nuts at lists.febo.com
>To unsubscribe, go to
>http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
>and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list