[time-nuts] Do time nuts only use and measure 10MHz clocks?
cdelect at juno.com
cdelect at juno.com
Fri Oct 7 16:01:34 UTC 2022
Erik,
When using a common clock into a DMTD it is fairly easy to make sure your
DUT and REF are close to in phase at the start of a measurement.
This allows the cancelling of noise from the offset oscillator.
However if you use separate clocks of different frequencies you will lose
that advantage.
For measurements that don't need ADEV better than parts in the -11 or -12
range it would probably work, but a trial would tell the tale.
Cheers,
Corby
More information about the Time-nuts_lists.febo.com
mailing list