[time-nuts] Lucent KS-24361 GPSDO arrived today several questions
GandalfG8 at aol.com
GandalfG8 at aol.com
Fri Nov 7 23:30:23 UTC 2014
Can't argue with that, was just responding to some comments re SatStat:-),
although I do find it quite handy sometimes as a quick confirmation all is
ok.
Regards
Nigel
GM8PZR
In a message dated 07/11/2014 23:10:36 GMT Standard Time, kb8tq at n1k.org
writes:
Hi
There was a post from Goetz Romahn about a new version of Z38XX that will
work correctly with the 3810/11/12. The previous version worked fine under
XP. It’s a far better program to use than SatStat.
Bob
> On Nov 7, 2014, at 3:48 PM, GandalfG8--- via time-nuts
<time-nuts at febo.com> wrote:
>
> Which one are you using?
>
> The bottom one referred to on Didier's site is the old Windows 3
version,
> perhaps even DOS, going back to 1993 or thereabouts.
>
> The later version is the one marked Satstat50, actually SatStat 5.0 and
a
> Symmetricom release from 2001.
>
> I can't try it on Win7 right now but did think I'd had it running
> previously.
>
> Regards
>
> Nigel
> GM8PZR
>
>
> In a message dated 07/11/2014 20:42:26 GMT Standard Time,
> xaos at darksmile.net writes:
>
> It seems that this program will not work for Win 7.
> Has anyone attempted to decompile this thing?
>
> Maybe re-work a bit and have it run on anything?
> -George, N2FGX
>
> On 11/07/2014 01:34 PM, Bob Stewart wrote:
>> Hi Bill,
>>
>> I think I got my copy here. I used the bottom one. I don't know what
a
> 58503 is. it was hard to find, for some reason. I'm using XP on an
old
> laptop.
>>
>> http://www.ko4bb.com/manuals/index.php?dir=05%29_GPS_Timing/SatStat
>> Bob
>> From: Bill Riches <bill.riches at verizon.net>
>> To: 'Bob Stewart' <bob at evoria.net>; 'Discussion of precise time and
> frequency measurement' <time-nuts at febo.com>
>> Sent: Friday, November 7, 2014 7:04 AM
>> Subject: RE: [time-nuts] Lucent KS-24361 GPSDO arrived today several
> questions
>>
>> Hi Bob and group,
>>
>> Where are you obtaining Satstat and what windoze version will it work
> on? XP, W7 32 or 64 bit? XP I guess?
>>
>> Bill Riches
>> Cape May
>>
>>
>>
>> -----Original Message-----
>> From: time-nuts [mailto:time-nuts-bounces at febo.com] On Behalf Of Bob
> Stewart
>> Sent: Friday, November 07, 2014 12:03 AM
>> To: Discussion of precise time and frequency measurement
>> Subject: Re: [time-nuts] Lucent KS-24361 GPSDO arrived today several
> questions
>>
>> Hi Bob,
>> I've been using the Satstat program to send commands. What I don't
> understand is why the slave will accept commands such as sat elevation
angle
> and not give an error response. It gives a response of "command
complete",
> but it doesn't change it. Or is that an indication that both units use
the
> same firmware, and success is actually indicated by the resulting
change
> of the angle?
>>
>> Bob From: Bob Camp <kb8tq at n1k.org>
>> To: GandalfG8 at aol.com; Discussion of precise time and frequency
> measurement <time-nuts at febo.com>
>> Sent: Thursday, November 6, 2014 6:07 PM
>> Subject: Re: [time-nuts] Lucent KS-24361 GPSDO arrived today several
> questions
>>
>>
>> ---
>> This email is free from viruses and malware because avast! Antivirus
> protection is active.
>> http://www.avast.com
>>
>>
>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list