[time-nuts] Looking for HP GPS splitter board

[John Ackermann N8UR]

This is a long shot, but...

A long while ago TAPR obtained and then sold some printed circuit boards
that were intended to go into HP GPS antenna splitters.

The boards were about 1.5 by 3.5 inches and had all the parts mounted
for a 4 port splitter, but with no connectors attached.  The part number
on the board was 58516-60001, Rev. G.

I would dearly like to find one or two of these boards to use in a
project.  If anyone has any they are willing to sell, please contact me
off list.

Thanks!
John
jra at febo dot com